well ill be doin this swap here very soon. my main concern is driveshafts. what will i have to do for driveshafts?? will i have to get custom driveshafts or is there a stock set of driveshafts i could use? another concern is radius arms, can i use 78-79 f150 or bronco radius arms and brackets...
i thought i remember a really old episode of trucks on spike t.v. were they went to a Bronco only junkyard somewhere in tennessee. am i right?? if so where is it at?
Went to haspin acres this weekend with some buddies and finally got to drive and wheel the B2 for the first time. unfortunetly it ended quick because of the front right axle u-joint ears breaking , but i wheeled with it in 2wd pretty much the whole weekend and it didnt do to bad for what i...
so im about to change my outer u joint on the passenger side. do i have to drop the center section or does the axle shaft come apart in two after the inner u joint?? if i drop the center section, would i have to remove the driverside axle shaft??
well about an hour ago, me and my buddy were passing through town and spotted a 84' 4x4 ranger for sale for $400. it looked clean, figure there was some type of problem with it being so cheap. but after talking to the owner, he was just hurting for money. so we took it off his hands in the 10...
well i hear nothing but bad things about it, im about to go on a off road trip with some buddies in about 3 weeks and been worried sick that im just gunna break axles shafts and be done the first couple hours of the weekend trip. ive did my research on the D28 and seen some guys tack weld the...
well it was working a few days ago, i ended up needing a clutch line, got that order and recieved it today, put it on and now im not getting any fluid through the master cylinder. is there a way to revive it or do i just have to bite the bullet again and buy a new one??
i noticed the snap rings are on the inside of the u joints. after removing the retaining clips, do you beat the cap inward or do they have to be beating from the inside out??
i found a set of 95 explorer axles for cheap. will they be a direct bolt in into my 89' B2? will my B2 driveshaft work? what problems would i run into?? what axles would be under a 95' explorer??
1st how the hell do you get to the bolt for the lower balljoint when the axle is over the top of it?? since the castle bolts are siezed to the balljoints and when i turn them with a socket, the balljoint spins. do i just cut the bolts off??
well ill need a new driverside axle and the wheel pinion for my 89' BII, would a ranger D28 axle be the same length and have the same splines?? heres a picture of my situation in case you dont know what im talking about..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.