Welcome Visitor! Please take a few seconds and 
- Joined
- Aug 13, 2007
- Messages
- 3,127
- Reaction score
- 23
- Points
- 0
- Location
- Illinois
- Vehicle Year
- 1995
- Make / Model
- FORD
- Engine Size
- 4.0 OHV
- Transmission
- Automatic
Talking about the passenger side vents on Gen-II and early Gen-III RBV's.
I recently replaced my broken passenger side vents. I broke the little tabs off trying to get the replacements off my parts explorer, AND when I removed the old ones on my Ranger. I glued the good ones into the dash, just to get them in.
Have these just gotten old & brittle? This just the way they are? or am I going about this in the wrong way?
The superglue holds them in tight, and snugly, and I can remove them if needed, but is there a better way to install them?
I recently replaced my broken passenger side vents. I broke the little tabs off trying to get the replacements off my parts explorer, AND when I removed the old ones on my Ranger. I glued the good ones into the dash, just to get them in.
Have these just gotten old & brittle? This just the way they are? or am I going about this in the wrong way?
The superglue holds them in tight, and snugly, and I can remove them if needed, but is there a better way to install them?
).
never taken those out before 
