Latest activity
-
Curious Hound replied to the thread Off center.Not trying to bust your balls. This is how we learn. Your 2.3 might have been centered. Give me a minute. I'll go see if my 3.0 is... -
No I assume it was because everything I had big motors etc in past was center , so probably the 2.3 wasn't center cause original trans...
-
-
rcone65 replied to the thread Off center.No I assume it was because everything I had big motors etc in past was center , so probably the 2.3 wasn't center cause original trans...
-
Curious Hound replied to the thread Engine height.If you want it lower, go ahead and lower it. That will drop your center of gravity a tiny bit and you'll have slightly less driveline...
-
Curious Hound replied to the thread Off center.Depends in where you put it. But, probably, yeah. Here's a question for you. Was your original motor and transmission centered? Did you...
-
rcone65 replied to the thread Engine height.If I use the rubber mounts it seems motor is high but ricks ranger said that's right but to me motor needs to set lower as lower it...
-
rcone65 replied to the thread Off center.So the 5.0 trans and motor will be center and rear diff will stay off center
-
Curious Hound replied to the thread Off center.That's how they're designed. It'll be ok.
-
Curious Hound replied to the thread Engine height.I don't have experience with those mounts. But I do have advice. "Do what you need to do to make your build work right." Very few...
-
Angry Possum reacted to lil_Blue_Ford's post in the thread Front Fuel Leak 1993 Ranger 4.0 XLT Auto with
Like.
Personally I found pulling the bed easier than trying to drop the tank to get to the pump. Also I’ve decided that once a fuel line... -
I had many low pressure pump failures back in the day. I'm not kidding when I say like at least 10 in one truck - they would last 6...
-
FildoDagginsRHEC replied to the thread My First Solo Build......mine is a pressed fit too. i wanted to make it one piece before i wrapped it in vinyl. -
I like the idea, but I think the shape is wrong. If it is you'd have to do some sheet metal work to make it fit.
