Latest activity
-
SomeBakerGuy replied to the thread 1999 Ranger No Crank Electrical Gremlin.I'll look into the fuse box as well. If I ground the column to the steering member (metal structure in the dash) all my issues go away...
-
Mackhedq replied to the thread LS swap! finally.Much better. Took it around the block but it has a P2534 Ignition Switch Run/Start Position Circuit code. I cannot seem to clear it or... -
ryan replied to the thread LS swap! finally.running better with fresh gas? -
Blew the dizzy apart tonight. Then I hit a wall, every video I have seen on the toob shows a screw in the end of the shaft that...
-
lil_Blue_Ford replied to the thread Leaf Spring Clamps.Those are the clamps I used on the green Ranger -
ryan replied to the thread 1 Ton YJ Crawler build.Next up is getting the wrecked steering box out and the Atlas a new input shaft. All the wiring to finish up
-
ryan replied to the thread 1 Ton YJ Crawler build.Fuel system is all together now except for one AN-8 fitting I needed for the return line
-
-
ryan replied to the thread 1 Ton YJ Crawler build.Took me a bit to get the hang of the stainless lines vs the nylon braided. Kept fraying them out, eventually used electrical tape...
-
-
ryan replied to the thread 1 Ton YJ Crawler build.I was hoping to mount my steering reservoir in the drivers fender area on the radiator, but that might be a little dicey now with trying...
-
Snug. But not TOO snug. Looks great.
-
ryan replied to the thread 1 Ton YJ Crawler build.This is a speedway branded one. Not sure what to expect - my buggy had a fass style setup, but it had all that high dollar racecar...
-
ryan replied to the thread 1 Ton YJ Crawler build.Holley compatibility- I didn't realize it at the time but they only want to work with specific throttle bodies. I had this nice Toshiba...
-
Lefty replied to the thread Leaf Spring Clamps.Sounds good. Sounds real good, especially those sway bars. The Ranger responds well to suspension improvements. Doesn't it? Still, if... -
-
alwaysFlOoReD replied to the thread Lookin for Dana 35 4.88 gear set.I do. Pm me. I probably won't answer for several hours. -
lil_Blue_Ford replied to the thread Wanted Pre-Keys and Blocks.I had thought about aftermarket keys for lowering but there seems to be very little information on the keys and a lot say that they’re...
