Big Block Drift Truck - Pic Heavy

[alwaysFlOoReD]

For some reason I thought you were going to flatten the top and mount the carb(s) directly. That would look pretty cool sticking out of the hood!

 

[bba952]

For some reason I thought you were going to flatten the top and mount the carb(s) directly. That would look pretty cool sticking out of the hood!

That was the original plan but the inside of the plenum isnt 100% hollow. so i would either have to cut it off completely and build a new plenum or cut the top off and hollow it out by hand. NOT happening.

The yellow area is solid and the blue lines shows the runner paths. one good thing is that the runners are equal length.

I dont want to spend the time to make significant changes to the intake right now, I just want to hear it run ASAP. i always feel more motivated after the initial start up. so im just going to 3D print some type of carb adapter and bolt it up to where the stock throttle bodies would be.