stalls out
-
2.9 stall when clutch is pressed
My 2.9 liter stalls when I press on the clutch. It's kind of sluggish to start when I have the clutch pressed. Once I release it during start up it idles fine. Only codes I get is #6 cylinder. Which I figure is a bad injector. The clutch and slave are brand new. Any ideas?- chavo6723
- Thread
- 2.9 clutch stalls out
- Replies: 0
- Forum: 2.9 Liter Forum
-
Fuel Vapor pouring out from back of engine (after top end rebuild)
I recently had the heads of my Mazda B4000 (94 Ranger) now its extremely hard to start when cold you need to madly feather gas and over rev until it gets warm then it idles fine. except from behind the passanger side head a white gas vapor pours out though Im unable to see exactly where it...- KootenayBoy
- Thread
- escaping fuel vapor hard start head gasket stalls out
- Replies: 6
- Forum: Mazda B-Series Specific
-
95 ford ranger stalls out
http://www.youtube.com/watch?v=PYEpb00ZtmM Please tell me what you think?!?!?! I need help with this and all these truck owners with a 2.3L generation 3 ranger!- Bish0psaid
- Thread
- 1995 2.3l engine fail ranger stalls out
- Replies: 0
- Forum: 4-Cylinder Engines (1983-2011)