hub

Hi All, I am quite confused. I have 2000 ranger ( 02/00 build). It's a farm truck, non-highway use. Recently it has left me setting a few different times in the snow. It will sit there and spin 1 back tire while in 4WD and the other tires sit motionless. It seems to have loss some power as...

i recently bought a 2002 ford ranger 5 spd manual with the manual transfer case. (i dont know if thats rare or not) . I ended up having to replace the passenger side front hub assembly and the half shaft. The problem arose when i went to take the half shaft out. I got the end out of the spindle...

Yesterday I took a look at my bearing because they were getting loud. Come to find out that the washer between my two lock nuts broke. (lock nuts I am talking about are here). The nipple on the washer that keeps it from spinning on the spindle broke. The metal that broke off obviously went into...

i have a 2007 ranger xlt manual 5spd. i have the electric shift.. whenever i click it over to either 4lo or 4hi i can hear it engage and the light comes up. the front wheels spin at first but after a few seconds i hear a grinding noise from the t-case and the front wheels stop pulling... any...

hi i recently bought an 87 ranger xlt 4x4, was replacing the front passenger side bearing and notice the needle thrust bearing, bearing spacer, and the axle shaft spacer are missing. mine are auto locking hubs WITHOUT an inner and outer spindle nut. the spindle nut on there is a hex nut, not a...

Awhile back at TRS suggestion, I bought Warn manual locking hubs (Jeep P/N 37780) for my 96 Ranger XLT and they worked great...never had a problem. That truck is now totaled, I'm parting it out and wondering if I should save those hubs for my new 2011 Ranger (Sport, 4.0L, V6, 4WD) at a later...

scroll to bottom for shorter verssion i recently picked up a 74 d60 from a 3/4 ton 8 lug f250. my problem was that 35 years have not been too kind to the brake assemblies and the backing plates were completely rotted out. so i trashed the backing plates and kept the drums and hubs since they...

I have an 89 Ranger and manual warn hubs, the hubs are good, and i JUST replaced the driverside U joint, STILL having a loud knocking noise, i've had a friend check and it's actually the ears of the U hitting the end of the bolt holding the bottom of the knuckle (hub?), u can see it just below...

i have a 95 ranger 4x4 with auto hubs i am debating wether it is worth putting manual hubs on my truck ?