• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

fabrication

  1. Frame flex

    Hello i am not sure if this is the best place to post this but on my Ranger when i was taking the transmission cross member out i noticed a lot of flex to the frame on the bottom lip, i could grab it with my fingers and move it up and down and almost bend it. The frame felt like it was very weak...
  2. 4banger_ranger

    front bumper idea

    does anyone have the measures and pics from their front bumpers theyve built??

  3. Tanks too damn small!

    I have a 1988 bronco ll and the thing is a pain, I constantly need to refill it with gas. I believe it has a ten gallon tank. I also dont see any postings about this, but does anybody have any ideas on putting a bigger gas tank in it, like sizes and if anybody has don a conversion like this before.

  4. Swapping coil spring front end with torsion bars

    So I'm working at building my 07 Ranger. My question is; Can I swap my coil spring front end with a torsion bar front end from an 02 without any fab work? I'm trying to build in stages so this will allow me to put my tires, fiberglass, and bumpers on while deciding on which suspension I want to...
  5. morgan946

    1 ton 2002 ford ranger sas ideas?

    any ideas for my 1 ton sas while i wait on my tax returns to come in?

Sponsored Ad


Sponsored Ad

Back
Top