• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

bearing

  1. nesralyrrej

    hub washer spinning..

    hey all, long time no see! did a complete front end refresh on the ranger (minus pivot bushings) and had a frustrating issue. truck is a '90 manual hub d35 ttb on the passenger side, the keyed hub washer with alignment holes for the inner nut was able to spin when torquing the outer nut.. the...
  2. 8.8 pinion bearing fit question

    Hi everyone. I'm currently rebuilding my rear axle and was checking the pinion bearing fit. The lower one needs to be pressed in, that was clear to me, but what about the upper one? When I handfit the bearing, it doesn't slide down on the seat. It seems that it'll have to be pressed in too. Not...
  3. Ranger T-5 swap with mustang hydraulic throw out bearing

    I have a 2003 5.0 ranger edge. I swapped in the T5 and used an older ranger master cylinder and universal slave. To use the older ranger master I had to drill holes through the firewall to mount it since the 98+ rangers master snaps into the pedal assembly itself. That lasted awhile but it...
  4. Mazda b2300 spindle/bearing issues and rotors don't match parts store inventory.

    Hello everyone, I am new to the forum and have been poking around on here for a while trying to come up with something to match my issue. With no luck and tired eyes I am posting for some advice. I have an 02 B2300 2wd that I bought about 6 years ago. One year in and the 3:73 rear end went...
  5. bearing noise, which one??

    my ranger has some bearing noise in the front while driving in a straight line, there is another roaring sound when turning left, how can i determine if its a wheel bearing and which one or if its a cv joint or pinion bearing?? I was also trying to find out if there are bearings where the...
  6. captainnova

    Help! Stuck wheel bearing race

    I went out to change the front passenger side wheel bearings, everything came off just fine but the outer bearing was completely shot.. all that was left was the race. Pretty sure it is supposed to just pull off, but it wont budge. Tried beating it with a hammer, any ideas of where to go from...

Sponsored Ad


Sponsored Ad

Back
Top