accelerating

Hey ya’all looking for some guidance on a problem I’m having with my 87 ford ranger v6 2.9. Few weeks back car stalled out at a stop sign and wouldn’t start back up. Replaced the ICM and got it back running but the idle was terrible after this and would stall out after driving and coming to a...

I have a 97 2.3 ranger, was having some problems that ended up being the MAF, truck is now running pretty good again. But I still have the problem with it accelerating after I let off the gas for 4 or 5 seconds. I don't think it's the throttle sticking because it seems to only do it if I'm...

So...I can't say I'm advanced in my automotive mechanical skills, but I know enough to tackle projects w the help of youtube/forums. I just tackled the replacement of my slave cylinder, everything went swimmingly and while I was down there I took the time to replace the clutch plate and...

When I am driving my 2011 4.0L sport I will occasionally get a deep vibration coming from the engine starting around 2500RPM, and it gets louder as you go higher to 3000RPM. the vibration sounds like going over rumble strips, and feels like going over a slightly rough part of road (not near the...

1999 ranger 4.0 @200,000 manual 4wd I recently checked and filled transmission, and front diff, and transfer case, then this clicking under load started, I rechecked the fluid levels, made sure nothing was overfilled, checked three sources as to type of fluid.. the little black rubber dust...