• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.


  1. sebastian323

    Spark plug wires very stuck on spark plugs - 1996 4.0

    The spark plug wires are VERY stuck on to the plugs on my 1996 XLT. The truck came from Montana so there is moderate rust on a lot of the engine parts not typical of California cars. Is there some way to break/cut the wires off ? I have only managed to change one spark plug so far
  2. 1984 Ford Ranger going needs lots of help thanks in advance.

    I inherited a 84 v6 ford ranger from my grandpa after he passed and been trying to get it up and running, issue is it sat for 17ish years so it leaves lots of love and then some. If this is not the right forum please move it to the correct one didn't know witch to post it in. So far new gas...
  3. wiring apush button latching LED switch

    you see these on Ebay a lot a really versatile little switch with a few options for installing
  4. how to wire a 7 Pin winch or accessory switch

    Lots of switches out there do not come with instructions especially if you get them for a bargain this tutorial may help
  5. Dprocks100

    Recovery Bible

    Found this little gem while researching ways to recover an ATV I lost off a cliff. Found it pretty useful, figured others new to extreme recovery that takes more than a winch or snatch strap would benefit from the info. Maybe we can make this a sticky or put it in the tech library if people find...
  6. nktidwel

    Ignition fuse blows..

    96 2.3 manual Every single time I attempt to crank the ranger (with just the key), the ignition fuse blows, and it does not crank at all. I followed the ignition wire (red/blue) from the ignition switch. I have continuity with the bottom terminal (black/heavier wire) of the fender solenoid. I...
  7. 93 2.3 Cranksensor wires?

    I have a 93 ranger with the 2.3. i replaced the complete under the hood wiring harness. The truck was not running when i bought it. I noticed there is a little yellows wire that runs to the crank area. it was not hooked up on my first harness. Yet i can not get y truck to fire should i wire this...
  8. electrical gremlin

    I recently decided to rewire my speakers because no set of speakers i put in the ranger were working properly. The original setup was custom and had all left side speakers wired together and all right side speakers together. I split them up and now i have no radio and no windshield wipers. It is...
  9. Tach problems on 91 2.3l ranger

    Hey everyone. I'm new to this forum, but I have been using this site for a while now and I find it extremely helpful. I can usually find an answer to my problem, but I wasn't so lucky this time. The tach on my 91 ranger (with the 2.3l dual plug system) hasn't worked right since i bought the...

Sponsored Ad

Sponsored Ad