• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

ranger 4x4

  1. MahLahChee

    1990 Ranger will not shift to 4x4 Low... unique situation

    Hey all! Searched everywhere online and couldn't find an answer, so I hopped on this forum to ask some of you wise folks. I have a very unique Ranger, 1990 single cab, 4.0 v6, automatic but was converted to a manual 5spd. The original electric shift T case was kept. Also has Dodge Dana 60 axles...
  2. Multiple Swap trouble

    Doing a 5.0 explorer swap into my 95 ranger. first thing to know is i have a custom 8in short arm suspension lift in my truck. i am doing a 97 explorer 5.0 plus trans. truck is regular cab short box 8.8 axles twin ibeam Was looking at using the explorer transfer-case or my current ranger one...
  3. Ranger 302 swap

    So i want to put a 302 in my 4x4 ranger but i don't find the guide descriptive enough, so i need to know the best way to fit a m5od-r2 transmission with an manual or electric tcase and what bell house to use on my 302 cause I've read many thing but they aren't super consistent and difficult to...
  4. Starting point

    Hello, I'm new to the world of Rangers. I bought a 2000 Ranger XLT 4x4 4.0liter about 2 months ago. I'm looking to see what I have to start with. My end goal is to have a good expedition truck, something that I can take to remote areas with out worrying about. I apologize if my questions seem...
  5. 2003 Ranger drive shaft broke in half!

    Hi guys, New member here; first of all thanks in advance for taking a look at this. Here's the short of it: I've a 2003 Ranger, 4x4, SuperCab, V6, EDGE package that I bought ~4 years ago. No big issues so far until coming from dinner this wknd the rear shaft drive broke in half (seemingly) with...
  6. Ford ranger engine/transmition conversion to f150

    Is it possible to fit a ford f150 v8 and 4x4 transmition under a 93-97 ford ranger??
  7. lift problems

    I put 2 sets of 1.5 inch coil spacers in on front coil springs to give it a 3 inch lift. Now I have bump steer that pulls side to side on highway. Do I need a drop Putnam arm and if so how much of one? It is a 93 ranger 4x4 has had alignment after spacers were put in.
  8. off roading overhaul need advice

    After some extensive online reading (still need more) I am ready to throw out my plans and get some advice from the forums! Ranger specs: (all stock) • 2001 Ranger Edge 4X4 SOHC 4.0L Automatic • Open 8.8” with 4.10 ratio • 151,000 miles (purchased at 110,000 miles) • 30” tires My goals: • 33s...
  9. theGreatDane

    Rim Selection Help!!!!

    So i am the proud owner of a 1999 ranger 4x4 supercab. currently i am looking for some rims, as my stock rims are ugly. my requirements are that they are black and semi cheap, as i am a college student with no money. In the future i plan on upgrading to 31s or 32s, but i can only afford rims...
  10. Just About done

    i have a problem with my belt and pulley setup. I have replaced the idler and tensioner pulley, as well as the power-steering pulley. The belt squeaks and squeals. It also ripped off a rib on the serpentine belt. before i replaced the power-steering pulley, it kept burning through belts. and it...
  11. Aftermarket Muffler

    Hi my name is Travis and I am new to TRS but moving on to my question. I have a 95 4x4 XLT ranger with a 4.0L V6. I have been saving up some money now and I looking into putting in a aftermarket muffler and there are a lot to pick from. Any thoughts or ideas or advice would be really helpful to...
  12. 94 ford ranger for sale

    i was browsing thru craigslist and i stumbled to on the add for a 94 ford ranger for sale.i contacted the guy thru email and he sent me some details about the truck.if u could give me good advice if it is a good buy or not thanks. i also posted the site address and the email that he sent me...

Sponsored Ad


Sponsored Ad

Top