-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
dana44
-
Looking for someone to cut dxf files using my steel ohio
Hey everyone I recently purchased dxf cut files for a Dana 44ttb truss, and I also have a 4x6’ sheet of 1/4” steel at home. I was wondering if anyone has a plasma table and would be willing to use my steel to keep cost down. You’re welcome to copy’s of the files. I’m located in new London Ohio...- powerstrokekid
- Thread
- Replies: 2
- Forum: Custom Bumpers, Sliders, and Cages
-
Dana 44 SAS
Hey everyone I have a 2006 Ford Ranger Sport 4x4 that I want to SAS and put a 44 up front. I know the basics to it but I'm looking for a detailed guide for some of the trickier stuff. I've seen most of the guides for older rangers but I haven't come across anything for the newer years. If anyone...- Jonsmith
- Thread
- Replies: 1
- Forum: General Discussions