• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

dana 30

  1. Dana 30 SAS

    Hello, I'm starting to do an axle swap on my 88 Bronco II with a dana 30 out of a jeep cherokee. I'm posting to get some advice on the best way to tackle this and maybe a list of what parts I'm going to need to be able to make it a mostly bolt on job.
  2. 83 ranger with Dana 30 help with bushings

    Hey everyone! I’ve got an 83 ranger that’s had a SAS with a Dana 30. The fella I got it from didn’t know too much about it, but I believe the front axle to be from 98 Grand Cherokee and the rear axle to be from a mid-nineties f150. It’s just a woods buggy but it makes finding parts difficult not...
  3. Solid axle swap 2002

    Hey all! First time poster, long time lurker. Here’s my situation, I have torsion bar suspension and I’m looking at a HP D-30 from a Cherokee with 1 ton steering and comes with stock coil springs. I’m not getting a D-44 or 60 as I’m set on a 30, whether it be leafs or coils. My main questions...
  4. Dana 30 SAS 83 ranger track bar bracket help!

    Hey everyone! So I’ve got an 83 ranger, recently bought. The owner previous to me did an axel swap with the Dana 30 off a 97 Jeep. The track bar bracket is not welded square to the frame and is sitting quite off center, as I found out when I took it in for an alignment. The old guy I...
  5. 982WDRanger

    Dana 30 Pinion Preload Issue!

    So I finished up re-gearing my Dana 30 the other day after hours of pulling the pinion in and out to get the depth and preload correct. Finally got an awesome patter and a good number on the preload, so I tore it all down cleaned it all up, put in my new inner pinion race and bearings, installed...
  6. 982WDRanger

    Dana 30 E-locker issues...?

    I am installing a Eaton e-locker in my HP Dana 30 soon and I have some issues I need some information on. From what I have read I need different bearings from the ones that come in the install kit with my gears. I need LM102949 bearings and LM102911 races for the carrier. For what I have seen...
  7. Flash Gordan

    Just another dana 30 sas...

    A friend of mine junks cars for a living. He must be doing pretty good at it since he just bought himself a used rollback. But onto my story. He dropped off a free 98 Cherokee with a non-cad Dana 30 with 3.55 gears and rolling on 31's in my driveway! Told me that I could pull whatever I...
  8. 92 Danger Ranger

    SAS Help

    I have a 92 ford ranger 4x4 with a dana 35 front ttb. my buddy gave me a dana thirty out of his jeep what all do i need to swap it in and run leaf springs other than front spring hanger and rear shackle mounts.
  9. Jeep Dana 30 under 96 ranger???

    I know this has been done and ive seen it on s10s. my questions r about width and the extent of work to be done. i have a 1996 4cyl 5spd 2wd ranger. i want to run d30 front, rubicon 4:1 transfer case, ford 8.8 LS 4:10 and disc brake rear end, custom driveshafts(JUNGLE DRIVESHAFTS). wat type of...

Sponsored Ad


Sponsored Ad

Top