-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
cut and turn
-
position dana 35.....
Gents, im in a bit of a jam. I really could use some guidance. Okay I have a 91 Ranger ext cab STX I put a lot of lift on the truck. I ground down all the factory rivits and installed all the new brackets. Then reassembled everything. Now, I also extended the radius arms. not being a real "4...- C130MARINE
- Thread
- Replies: 6
- Forum: 4WD Suspensions & Frames
-
Cut and turn project
Around new years I dove into a cut and turn d35 project. I set my goals: 4" added spring height for 6" of lift, and strategic bracing to make the beams stronger. I want to run 35's when all is said and done. I did a bunch of research and looked at alot of set ups. I decided against relocating...- MAranger
- Thread
- Replies: 8
- Forum: Custom Bumpers, Sliders, and Cages