breaks

I changed out the front pads on my 94 2WD 3.0 ranger and I am now getting pad rattle from them so I feel really stupid for asking these questions but the answers are need to know to stop it. When I removed the driver side there was no anti-rattle clip installed and the passenger side clip and...

I have a 94 Ranger XLT super cab 4x2 with the ABS light on. I pulled the code and I get a code 4 but searching the internet I can not find a list of what the codes mean. As far as I can tell this code means "RABS valve switch closed or open dump valve." This information was taken from a 91...

when i turn on the headlights the break lights do not turn on when i press on the breaks they do turn on. what could make the lights only come on when breaks are pressed

My bronco II break light sensor will move and adjust but it will not stay in the correct position meaning it will work once but if I go to break a second time the position moves and wont stay where I put it. Does any one else have this problem and how would I fix that? Sorry if this is an easy...

Hello everyone! I was recently replacing my front brakes on my 03 Edge (with a haynes manual) and I had no problems getting the rotor and caliper off, but sure enough I couldnt figure out how to get the Inner grease seal out of the old rotor of for the life of me! The haynes manual says just pry...