1995 B4000 4.0l 4x4 5 spd
I need info and wisdom from the experienced:
I want to upgrade my 1995 b4000- differentials from 3.23 open to 3.73 l/s.
My front axle is a Dana 35.
I do not want to buy new. I want to snag used replacements.
1. Do I have to replace the entire axle / housing...
I have a 95 b4000 4x4 5spd. that I have put a lot of maintenance into through the years. I love it and it has served me well. The engine has between 200k-300k on it; ( the speedo/odo did not work for 19 yrs)
Now I need to change head gaskets. I'm a little concerned with this much mileage what...
This one has me totally stumped:
All modes of my hvac work great... for about 30 minutes. Blows Cold a/c, or great heat. Vent, floor, and defrost all operate as designed .... for about 30 minutes. AND THEN after about 30 minutes it is as if all intake air is shutoff. During these times, almost...
My Tach is not accurate. 95 B4000 4.0 4x4. 5spd man.
Idles at 400-500. Max revs 3500. Any suggestions? I've had the instr panel out to check connections. ( I know the 4.0 ohv is not a high rev engine. But I'm pretty sure it goes higher than that.) any help is appreciated.... considering...
I have a 95 B4000 4x4 4.0L
Is it worth the time and effort to swap for a Sohc engine.
1. if so, are they all the same or is there a desired year SOHC.
2. does it bolt up to my 95 5 spd manual?
3. are there PCM/ECU issues?
I plugged my OBD 2 scanner into the plug on my 1995 B4000 SE 4x4 4.0 OHV
I got these codes:
P0500 Vehicle Speed Sensor A Malfunction
P0141 O2 sensor Heater Malfunction B1 S1
P0155 O2 sensor Heater Malfunction B2 S1
P1151 Lack of upstream heated O2 sensor _______switch; indicates lean...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.