Search results

Looking for a set of hubs for my Bronco II, Stock D28. Located in southern CO

Got rid of my ranger a couple years ago and just been doing other things. Picked up an 89 Bronco II yesterday, good solid body decent interior, good running 2.3 and 5 speed, yes It has a 4 cylinder. Previous owner had a wrecked ranger with a good engine and a bad engine in the bronco. Has a few...

So I put some 2 inch drop coils in my 92 ranger and now its sitting on the bump stops. Is this normal?

Ok, I have been thru the tech section about what seats will fit and my pick n pull here has a bunch of mustangs, but not much for anything else on the list of seats that bolt right up. My question is, is there any specific years of Mustang seats that fit or are they all pretty much the same? The...

I just did the shackle hanger flip on the rear of my 92 ranger and was wanting to go about 1 inch lower in the front. All I can find is 2 inch and up for springs or beams. Anybody know of a source for 1 inch drop springs?

I have a 92 ranger that I am looking for wheel studs for, problem is that I need longer than stock. Anybody know where to find these? I have already tried all the places that I can think of.

I picked up a Ranger 8.8 out of a 96 for my 92 today for $50. The ring and pinion and carrier bearings are in good shape but it will need axle bearings and seals. Reason I got it so cheap was the spider gears are bad. So I am going to need some spider gears for 28 spline axles and while in there...

Is there any other engine with the same belhousing pattern as the 2.3? Tried searching without any luck, could only find answers for the V6's.

Okay so I got all my dash lights replaced and now it has a code showing. 92 Ranger 2.3 showing this code. 327 (O,R,M) EGR feedback signal is/was low – EVR or PFE Ok so its something to do with the EGR, any ideas what?

I picked up a 92 XLT that needed a lot of love. One of the things missing was the Battery hold down, I found a hold down but am wondering if anybody knows what size bolt it uses.

92 Ranger 2WD 5 speed. I am looking for the clip that holds the master cylinder push rod on the clutch pedal. Anyone know where I can get one? Thanks

I have a Dana 30 that I am going to refresh and use for a SAS. My question is has anyone ever looked into seeing if the locking hubs off a Ranger/B2 will work on this. It is a HP unit from a 99 XJ. Would like to be able to unlock the front end as it is a daily driver, but not willing to spend a...

Does anybody know where I can find a Factory service manual to download for my 1989 Ranger?

New to the site but not to offroading. I currently have an 89 ex cab Ranger 4x4. Totally stock with 2.9l and a 5sp. No plans for it yet as it is a daily driver/hauler for my Samurai.