i put a new cat in my exploder last month, it was a magnaflow direct fit and now every now and then i smell sulfur, like the cats bad already. anyone got any ideas what might cause this?
was wondering if anyone might know what would keep the dome light from comin on when the doors are open? i can turn it on with the headlight switch but wont come on when any of the doors are open
i have a 92 exploder and last wed i pulled off the maf, throttle body, and iac and cleaned them all real good. ever since last thu the motor idles at 1100-1300 rpm. ive already checked for vacuum leaks and cant find any, anyone else got suggestions on where and what else to check?
i recently replaced the tranny in my 92 exploder and was wondering if anyone knows what causes the engine idle to raise 200+ rpm when shifting from park to reverse cause it did it with the old tranny too, just went up more rpms.
we were driving on the highway yesterday and the transmission started leaking fluid and smoking behind the truck, and when i pulled over and was idling it was hemorrhaging from between the bell housing and the block, does this mean that the front pump seal is toast? or is it the converter gone bad?
i have a 92 exploder 4 door auto with 165,000+ miles on it, would it be safe to change to mercon v in the transmission? and what would be the best programmer for it?
i have a 92 exploder with the twin traction beam front axle and was wondering if i can remove the driver side axle beam to look inside the diff and make sure nothings wrong with the gears? I also want to get in there and clean it out real good
i just recently picked up a 92 exploder and am changing the tranny fluid soon, if i drain the torque converter do i have to put a couple of quarts in and then run the motor for a few seconds and then put the rest in, or can i just put it all in and start it?
i have an 85 ranger xl with the 2.3l. my motor had over 240,000 miles on it and ended up needing a different motor so i got a hold of one that was the same, with the same options and everything. i got the motor in and ive gotten it to turn over, but it wont start. do i need all of the engine...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.