After trying to diagnose some minor engine codes earlier (O2 sensor, coolant temp sensor) my truck now runs terribly and is un-drivable.
Accelerating from first gear is very laborious, the engine surges and I can hear the drivetrain clunking underneath as I lose power. Once the truck is moving...
I have a '94 Ranger, 2.3L with about 175,000 mi. When I start the truck up it runs okay for a few seconds before dropping down to a lower, rough idle speed. It also throws an engine code at this point "coil circuit failure on cylinders 1, 2, 3 or 4".
Gas mileage is low, and it smells very...
I have a code 224 "coil 1,2,3 or 4 circuit failure". I'm not sure how to go about fixing this, I put in new coils and got the same error code.
It's the 2.3 EFI with twin plugs per cylinder. It runs and always starts, but it runs rich and I want to figure out the problem.
I heard replacing...
My 1994 fuel-injected ranger seems to be running fairly rich and I'm not sure how to adjust this.
Idling it smells pretty bad, even though I get 16-17 MPG or so. I have a check engine light on the dash but haven't taken it to the dealer to get diagnosed yet, I was hoping it's something I could...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.