I'm thinking about selling my truck in the near future and was wondering roughly what these go for? It's a 1996 STX 4wd, extended cab, 5spd 4.0L. There is some small damage behind the driver sided rear wheel, but other than that it's really in great shape (some rust bubbles on tailgate and...
How long do these typically last? My truck has had the usual tune-up stuff done (has 105k and I changed the plugs/ wires/ air and fuel filters/ cleaned the MAF) but it now has a little miss (2k on tune-up). The only thing I haven't changed is the coil pack.
So I just changed the upper/lower hoses and T-stat, put the truck back together and take it for a ride. Everything was going good until the battery light came on. It's an older Optima battery, but seems to be holding a charge just fine. I put a tester on it and it's at 12.63v. When the truck...
Anyone ever run these before? They are the Discount Tire brand...they have a deal going right now, but wasn't sure how they were.
Also, I'd like to go with a 15x8. It sounds like the correct B.S. would be like 3.75", does that push them out too far?
Does anyone know what length one should be for a 96 4x4 ext. cab? I just bought one that the guy swears is out of a 99 ext. cab, but it's about 4" too long. Would the 2wd version be longer since it's not going to a transfer case?
Also, I know my stock 2-piece has the slip joint for...
I have a 96 4x4 and the front shaft had a double carden joint. I saw the article in the Tech section (I'm changing U-Joints), but I'm having a hard time finding the rubber piece that has the needle bearings that the cv type ball goes into. Does anyone know exactly what it's called and where to...
I have a 96' Ranger with 15" wheels and would like to upgrade to the newer 16" wheels. My question is, what year can I fit on my truck (I know the hub becomes the issue).
I have a 96' 4x4 STX 4.0 Ranger that I'm in the process of replacing the ball joints on the passenger side and figured I'd do the u-joints while I'm in there. My question is, how is the stub shaft (I think that's the correct name) come out of the front diff? Are there c-clips or something...
I have a 96' 4x4 STX 5spd that needs some suspension work. I figure while I'm doing it, I might as well level it off. What brand springs (thinking 1.5") and what are some good shocks for these truck? Is there anything else that will need to be changed? Would spacers work just as good as new...
Does anyone have any ideas? While driving down the road at lower RPM's, the truck likes to surge/ stumble a bit. Seems to be doing it under harder accelleration as well.
It has 103k on it. Here is what I've changed trying to get rid of it:
- Plugs/ wires
- Fuel filter
- 02 that was...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.