Search results

New update: It runs and drives! Still some minor stuff to work out, butI jumped the tan/red and pink wires (iirc) on the dtr plug and it fired right up. O/D off light is flashing, so that will take some sorting (maybe just jump the connector that went to the button?) Got a CEL as expected about...

Queen Creek is a distant southeast suburb of Phoenix. Haha, Radwood is big car show/event strictly for 80s/90s cars/trucks, which I for better or worse have a bunch of. They have one in Austin every year at COTA that's usually around 1000 cars. I've road-tripped the Starion to them all over the...

Thanks man. As for the slave cylinder situation, the car in question is an 88 Mitsubishi Starion. The only part AZ is going to have for it is some chinese floor mats. 😂 But yeah, slave blew out just outside Austin on the way back from a Radwood show. Key-bump-started it and rev-matched shifts...

Again, thanks for the response and info. At the expense of sounding like an idiot, I'm going to try and verify the possibilities here with a pretty terrible diagram. Excuse my ignorance, I just don't want to mess anything up after going through all this. (Suffice to say, this project has...

So, quick update: This project got pushed aside a few times with work stuff going on, and also I have a lot of cars that are needy, so tending to the easy quick stuff takes precedence. Anyway, I managed to locate the block spacer plate from the second dealer I tried. It was *really* expensive...

Thanks for all the good info guys. I really appreciate it. Things have been busy lately so haven't had much time to mess with it, as it's kind of our 'summer' in AZ, but I did manage to hit 4 yards today....unfortunately not much to show for it. I found a clean floor plate for the shifter with...

So, I had originally intended to gather up all the parts to do this and schedule a weekend for it, but thanks to an unintentional engine rebuild, it's just kind of happening now as there is no reason to put the auto back in at this point. I've been researching it for a while, and have a pretty...

Greetings. I've used this as an info source for years, but finally registered as I'm in the middle of some big projects (full 4.0 OHV rebuild and manual swap) and could definitely use some additional info on some details. I'll make a new post in a tech forum when I've exhausted a few searches...