OK, well, I was hoping for some better news on these parts...
scotts90ranger - can you post or send me a link for that nylon pipe tape you used?
I want to put that on the hose before I install it in the hopes that that will keep it from rotting away too quickly.
For the Filler Hose: $54.79...
Checked a few sources and I can't believe how many comments there are on getting a Fuel Pump that doesn't fit or has clearance problems, is dead on arrival, or that fails within 30-90 days requiring removing the bad Fuel Pump and replacing again.
Even if they replace the bad unit under...
Here is what I have left - It attaches with 3 small bolts.
Looks like it covers the leading edge (toward the front) and then stops where the caliper covers the rotor toward the rear.
Does the 4WD version look anything close?
Hi @rumblecloud - I've been looking but no luck so far - How did you fabricate your own?
Can you share the materials, dimensions, etc. - do you have a template of blueprint?
Need to replace the front disc brake splash shields 1994 Ranger XLT - 2.3L - 2WD.
Ford P# E9TZ2K004B - For 2 WD - I'd take the 4WD and then trim to fit if I could find them.
4WD P# - fotz1214a or FOTZ*2K004*A.
Shown here: Front Brakes for 1994 Ford Ranger | TascaParts.com
or at 1989-1994 Ford...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.