• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Recent content by thcscubajohn

  1. thcscubajohn

    For Sale TwEECer RT for sale $300

    Its still for sale, if you still want it ill sell it for $200+shipping
  2. thcscubajohn

    For Sale 1993 navajo/1997 ranger

    Front steering knuckles from the '97 if its a 4.0/D35
  3. thcscubajohn

    For Sale Parting a 94 4.0. (Engine only)

    4x4? I need a 27 spline axle thrust washer for a D35. I only need 1 and a snap ring would be helpful too.
  4. thcscubajohn

    Dana 35, 27 spline axle thrust washer

    Can aybody share a link or a part number for this washer? I lost the c clip and washer from one side of my truck. I can find new c clips but no washer.
  5. thcscubajohn

    4.0 OHV how to tell which wire is for which o2 sensor

    Thank you Ron. You always have the right information.
  6. thcscubajohn

    4.0 OHV how to tell which wire is for which o2 sensor

    Ok so its a pain in the nuggets to fiddle with these wires. I managed to take pictures of the wires and they are plugged in correctly now. Driver's side bank 2 has the red/black; And the passenger side bank 1 has the grey/blue; I'm glad I got the sensor with the longest wire for both sides...
  7. thcscubajohn

    4.0 OHV how to tell which wire is for which o2 sensor

    Ok, I switched the wires and drove it. It seemed ro run fine warm before. I did get an intermittent check engine light that would clear itself if I kept driving or restarted the engine. There was no change to drivability with the code. Now there is no code, but it won't idle down. The rpm won't...
  8. thcscubajohn

    4.0 OHV how to tell which wire is for which o2 sensor

    I would, but its pre-obd and I somehow lost my diagnostic port when I swapped cabs
  9. thcscubajohn

    4.0 OHV how to tell which wire is for which o2 sensor

    I recently installed my engine and I can't figure out which plug is for which o2. They bothe dangle down from the middle and could go to either side. One has a pink wire protector and the other black.
  10. thcscubajohn

    1994 Ranger 4x4 10.5 N/A build

    Photo Update: Cylinder bores were way too big due to me using an incorrect spec. This resulted in extreme piston slap and ended up cracking ringlands on all of the pistons. One of the pieces worked its way into the combustion chamber and shredded the #4 piston. This caused excessive blow by and...
  11. thcscubajohn

    For Sale TwEECer RT for sale $300

    I have one practically new tweecer RT for sale. Had it installed for a couple of weeks and decided to go a different direction. $300 shipped lower 48. $50 extra to ship it anywhere else.
  12. thcscubajohn

    '94 Ranger 4x4 HD

    The frames are the same. I'd be more worried about wires and steering column. Maybe Hvac. But it is for your car, you have a 2000, it's for a 2000.
  13. thcscubajohn

    '94 Ranger 4x4 HD

    If you're worried about fitment get the shorties
  14. thcscubajohn

    '94 Ranger 4x4 HD

    They say 1998-2000 so I think you'll be fine.

Sponsored Ad


Sponsored Ad

Top