Recent content by pimtool

Does the 2.9 rely on the fumes from the canister when the throttle is opened? In other words, if the fuel tank is not vented to the canister will this cause the engine to run poorly when the throttle is opened quickly? Can the the vacuum line that goes to the canister be removed and plugged...

I originally put this in the bronco2 section, but i think there is a little more traffic here. 89 bronco 2, auto trans, manual t case I just got an 89 b2 thats obviously been neglected. New fuel pump, filter, plugs, wires, cap, rotor, set timing. It starts and runs ok, bit of a miss at...

89 bronco 2, auto trans, manual t case I just got an 89 b2 thats obviously been neglected. New fuel pump, filter, plugs, wires, cap, rotor, set timing. It starts and runs ok, bit of a miss at idle. If i slowly press the gas it revs fine. If i open throttle quickly it boggs and coughs, If I...

Will the rear spring hangers from the 90 to 04 rangers work for a 89 bronco2? The ford parts man told me the rear hangers for the B2 are obsolete and not available, he said he has no dimensions so I cant measure to see if it will fit. Thanks.

Can you use wheel spacers on the d35? Will the spacers fit over the lock outs? Will this cause them to explode? Will a lock right, 5.13s and 35s change the results any? Any thoughts or concerns? Its a 94 4door exploder with 6in lift and 35s. Thanks.

I just got a 97 expedition 4x4 with 20" rims and low profiles. I would like to go back to stock. Does anyone know what years will and will not fit? Thanks.

little wheelin at gulches off road park in south carolina http://www.youtube.com/watch?v=otFSs77iHVk

http://www.youtube.com/watch?v=IvP4F_uaE0g http://www.youtube.com/watch?v=VjNO2g4EDvk

I believe so, when I was looking at 5.13s for a d44 , it said for use with 3.92 up carrier. so it must be a thicker mounting surface or something. Im not the expert, but thats were I would start looking. good luck.

Did u use the carrier for 3.92 gears and up?

http://backcountry4wheelers.com/fliers/Spring2011Event.htm

I havent posted pics in a long time, workin on SAS. Still have some stuff to do but here is the basic idea.

Putting a 77 f150 dana44 under the front of my ranger. (full width) I dont really want to go through and completly rebuild the matching 9" i have. (im lazy and dont want to spend the money if i dont have to) Does anybody have any experience with adapter/spacers? I havent measured yet to see...

http://www.youtube.com/watch?v=sQ0zyRzmvgs http://www.youtube.com/watch?v=z_YCqCYaFQ0 http://www.youtube.com/watch?v=yLAUEI0FStg

If the big green buggy looks familiar, it is the one that ran the top truck challenge. 54" baja claws. they are huge. http://www.youtube.com/watch?v=1Qv-4BO-E1I