Recent content by no class

It does move freely, yes. I'm not sure if it's possibly too freely moving. It could possibly be worn bushings binding. That's about the only thing i can think of.

I haven't checked that. The plug appears solid, I'll check it out.

You can hear the two different relays clicking independent of one another. The part that doesn't make sense is when plugged in, but not attached to the linkage, it works perfectly. The speed of the motor changes with the multi-function switch and it returns home when shut off. As soon as I hook...

1999 Ranger and the wipers stopped working the other day. Did one wipe, paused and then did it two mores times, but only on high. Then it died. I guessed it was probably the motor since it was a used replacement the p.o. put on (has writing from a junkyard on it) So I bought another used one to...

Does anyone have the wiring diagram for the airbags on a '99 Ranger? I use the truck off road and would like to see if it's possible to modify the wiring so both bags turn on/off with the keyed switch. I'd like to have the airbag while on-road, but not so much off road.

I think the Coyote is slightly smaller than the 4.6 There is a guy on FTE that started on a coyote swap and got as far as getting it installed. The swap never got finished.

Yeah, that's them.

I have a 99 non-Flex 3.0

I used a stud/nut set for a 5.4 rather than the bolts.

Had this issue with mine. It will only latch if I close it with some force with my hand directly over the latch in the middle. Fortunately I have no reason to go behind the seat now that it's latched.

.

Awesome, thank you!

Anyone have a manual handy? I need the torque spec for the cam gear bolt. It's a hollow bolt so it can't be too much. I have looked online and found a few different numbers. It's a 2003 if it matters.

An explorer 8.8 will take a lot more abuse than you think. Lots of junkyard LS/ebay turbo builds putting 5-700 hp through an explorer 8.8

If the bolts feel like they are too tight or may break I just fire up the torches and blow the heads off. Once the manifold is off you can get a set of vice grips on the stud and it usualy comes out pretty easy.