Recent content by dniksch

POLK.... How or which way do you measure for 7/8 to cut??? thanks I cut the top part of the coil about one full revolution. from the top end around one full curve. is that correct? I only want upto 2 inches in the front.

I get up to 55 or plus and let off and the truck stumbles or jerks after I take foot off the gas. Any ideas?

189 code comes up and I just replaced the left/front O2 sensor/Bosch. 189 means running lean. Any ideas why? I do take it left is the drivers side? Right?

I know it is on here somewhere but... How do I pull the codes on my 93 3.0 auto. ??? I did search the tech page but don't know which method to use. Thanks for the info

Should I go with a Ford O2 sensor/s or aftermarket ok and if so which ones are best. I did a search on here for this question and didnt find an answer for me. Thanks for the help.

93 standard cab long bed. Rear Driver side brake / turn signal light is not working. Bulb is new and was wondering where do I find a wiring diagram to trace down the wiring??? Thanks for the help

how about a small torch to get out the rivets? would that be easier and faster

where do you look to get extended shackles?

I have a grinder but not sure if it would get to the top rivets. Thanks for the info for the front hangers too. will have to start grinding. One last question what size bolts are needed to replace the rivets? Thanks again

Mullins81, did you take off the bed and if you didn't what did you use to remove the rivets? I have read the tech article and don't have air tools. Thanks

I have a 93 3.0 auto. I am leaking trans fluid and it is leaking but not sure where at. I figured it is a line but not sure how to trace them or what to look for? Was wondering where to look for a diagram for the trans lines? the trans fluid is leaking and being thrown around by the front/fan...

Just the rear. Front ones are just a mount off the frame the leaf spring mounts to.

and yea have used the lovely search feature

Thanks, I seen these pics before and to me ??? looked like the shackle in the two pics is reversed/ the direction it is facing?

I have a 93 ranger and want to flip the rear leaf springs. Other than grinding the rivets out and replacing them with bolts.... what do I need to do? Does one shackle move over to the left side to the right? Also, will I need to replace the shackle bushing? Thanks for all the info, Dave