i got a buddy going to do sas with d44 full width and 9" rear. but i need to know what drive shafts im gonna need. the truck is a 89 ranger 2.9l 4x4 and for now i will have this engine tranny and trans for now. so what drive shaft would i need or how do i go about finding out what i need. thanx
sas drive shafts??
- Thread starter quaallen
- Start date
- Joined
- Aug 6, 2003
- Messages
- 619
- Points
- 5,101
- Vehicle Year
- 1993
- Transmission
- Manual
You go about finding out what you need by putting the axles in the truck, and then measuring the length needed. It's pretty straight forward...
sweet . thanx
- Joined
- Aug 13, 2007
- Messages
- 1,193
- Points
- 3,101
- Age
- 41
- City
- Osceola Mills, Pa
- Vehicle Year
- 1988
- Transmission
- Manual
Highly doubted you will find one that will fit from the junkyard. If you have a good chop saw, tools to ensure you have a square cut and a welder you can make a driveshaft. Depending how good you made it you will be able to get it balanced. If you doubt your skills just have a shop make it.
Matt
Matt
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
