Cut and turned beams?

Bennybooster · Apr 18, 2010

What is needed to use cut and turned beams.
What problems would i run into (axle shaft length stuff like that)?
Who makes a good set?

Zombiemoto · Apr 18, 2010

longer shocks,springs, longer tierods, brake lines, you can use an f250 axle on the passenger side driver side must be fabbed, check camburg and giantmotorsports for kits

Ranger#1 · Apr 19, 2010

another cut and turn for a local customer send me a pm if you have ANY questions at all

Bennybooster · Apr 19, 2010

Do cut and turned beams handle well on the street cause its going to be dd for a while.

Ranger#1 · Apr 19, 2010

yes along as you get appropriate steering

dave@threat · Apr 20, 2010

Now add an overlay on the bottom side so they dont fail. Practice more with your welder too. You need more heat and you need to slow down!!!

Ranger#1 · Apr 21, 2010

the spacer is doubled up 3/16 do u really think i need an overlay iv seen quite a few both ways if so yess do ya think 1/8 will suffice

and that weld was super slow i just didnt have a love gap for the weld to fall in to

Bennybooster · Apr 26, 2010

Any other info you guys could give me on the whole prerunning deal would help a ton im kinda a noob when it comes to the fast stuff.
Also on a different note i want to get 2 to 3in of lift in the rear with 64in leafs would i need to flip the shackles or what?

Carson · Apr 28, 2010

sry to post jack but roughly how much to you space out the ball joint hole on each side, looks about 3/4?

Ranger#1 · Apr 30, 2010

Bennybooster said:
Any other info you guys could give me on the whole prerunning deal would help a ton im kinda a noob when it comes to the fast stuff.
Also on a different note i want to get 2 to 3in of lift in the rear with 64in leafs would i need to flip the shackles or what?

if you flip your shackle your going to loose around 4 inches of lift
search on dezertrangers.com it is a welth of knowledge

Ranger#1 · Apr 30, 2010

Carson said:
sry to post jack but roughly how much to you space out the ball joint hole on each side, looks about 3/4?

dvr side is 13/16 pass side is 1 inch

Little X · May 21, 2010

How many inches of lift is that for? 4?

Cut and turned beams?

Bennybooster

15+ Year Member

Zombiemoto

15+ Year Member

Ranger#1

15+ Year Member

Bennybooster

15+ Year Member

Ranger#1

15+ Year Member

dave@threat

15+ Year Member

Ranger#1

15+ Year Member

Bennybooster

15+ Year Member

Carson

15+ Year Member

Ranger#1

15+ Year Member

Ranger#1

15+ Year Member

Little X

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions