Dana 35 Axle Lock Clip

91Exploder · Sep 4, 2007

Stupid me i took out the axle lock clip out of my 1991 explorer front axle to relase the inner right axle and threw the clip away. I was wondering where i could get this clip? any info will be appreciated. Thanks

martin · Sep 4, 2007

Not stupid at all, that's the best thing to do with the e-clip. By using another method to hold the stub in place you will be able to change the u-joint without pulling the pig from the beam. There should be an article about e-clip eliminater in the tech library. I used a different method on mine but I will not post it until I have more test time on it.

Wicked_Sludge · Sep 4, 2007

dealer only.

so junkyard or dealer.

Will · Sep 5, 2007

http://www.therangerstation.com/Magazine/Fall2003/MaximumFlexForTheTTB.htm

That's the method I use.

peter@ncws.com · Sep 11, 2007

forget the clip, you don't need it.

You just need to go to a auto motive machine shop and get a valve spring(off of a 4cyl. preferably, one that they replaced) and put it between the short shaft and the long shaft. Works like a charm and you can pop that puppy out without pulling the whole 3rd member. If the tension is too much just cut the spring a little bit.

Dana 35 Axle Lock Clip

91Exploder

10+ Year Member

martin

15+ Year Member

Wicked_Sludge

15+ Year Member

Will

Forum Staff Member

peter@ncws.com

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions