- Joined
- Aug 7, 2007
- Messages
- 77
- Points
- 3,101
I should be getting this project in the next few weeks. Have to arrange a wide enough trailer to haul it. What is has so far.
Full Width Dana 44 front out of 78 Bronco, stock 3.50 gears, 7 degree bushings, 5.5'' lift early bronco coils
Full Width 9'' 31 spline rear, shackle flip
Has the start of a 302/C-6/NP205 swap.
It needs most of the stuff done to it. It's at the begining stages at the moment.
Plan is to mini spool the rear, weld the front, throw on the 36'' Irok's I've got, get the motor trans and t-case installed and go have fun.
Full Width Dana 44 front out of 78 Bronco, stock 3.50 gears, 7 degree bushings, 5.5'' lift early bronco coils
Full Width 9'' 31 spline rear, shackle flip
Has the start of a 302/C-6/NP205 swap.
It needs most of the stuff done to it. It's at the begining stages at the moment.
Plan is to mini spool the rear, weld the front, throw on the 36'' Irok's I've got, get the motor trans and t-case installed and go have fun.
Last edited:
