- Joined
- Jul 2, 2009
- Messages
- 1
- Points
- 3,001
- Vehicle Year
- 2001
- Transmission
- Automatic
Ok, my ranger just hit 100k and has a little rough idle, so I'm changing out the plugs and wires, and pcv valve, however I just want to make sure I pull the right valve. So I thinks it's on the drivers side next to the firewall on the valve cover. I b..ch to get to as it's right under a wireharness.
Is this the right spot...cause of all the researching I've done I've read it is in three different spots..this being one of them.
Also the pcv valve I got from Checker looks different than the Motorcraft symbol that's on the valve that easily just slides out, they sold me the MicroGard, (fram replacement) for like $1.60. Would this valve be ok to use or should I hunt down a motorcraft valve?
It's the V6 3.0 Vulcan I believe....2001 XLT.
Thanks in advance....
Matt
Is this the right spot...cause of all the researching I've done I've read it is in three different spots..this being one of them.
Also the pcv valve I got from Checker looks different than the Motorcraft symbol that's on the valve that easily just slides out, they sold me the MicroGard, (fram replacement) for like $1.60. Would this valve be ok to use or should I hunt down a motorcraft valve?
It's the V6 3.0 Vulcan I believe....2001 XLT.
Thanks in advance....
Matt
Last edited:
