• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

what driveshaft for 6" lift?


bigfltruck

bigfltruck

Well-Known Member
Joined
Dec 27, 2009
Messages
61
Vehicle Year
1992
Transmission
Automatic
i have a 89 bronco2 im fixn to lift 6". it has a 2.9 v6, with a 5 speed trans, manual 1350 transfercase and stock axles. i want to know if there is a drive shaft that i can use for the rear that will just bolt in so i dont have to drop $$$ at the shaft shop. thanks for eney help.
 
I used the stock driveshaft out of an '84 Bronco II (had a C5) in my '87 with an A4LD. I cut the CV part off because it would have been too long. I would think that you should almost be able to use the one that came with it - mine was the shitty GKN type with two CVs - and it fit, but it was really worn out so that is why I swapped.
 
Find a 1354, remove the front yoke, install front yoke on the rear of your 1350 and install the front driveshaft from an explorer on the rear of your b2.

nicksranger033.jpg
 
You must log in or register to reply here.

Sponsored Ad


Sponsored Ad

TRS Events

Member & Vendor Upgrades

For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.

Latest posts

Recently Featured

Want to see your truck here? Share your photos and details in the forum.

Ranger Adventure Video

TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_0790.jpeg
20250606_193025.jpg
20250717_161404.jpg
2f30d2e5-a0b6-4419-bb34-5c120604fb82.jpg
IMG_0673.jpeg
IMG_0675.jpeg
IMG_0671.jpeg
85 ranger
85 Ford Ranger
PXL_20250409_152004355.jpg
IMG_9440.jpeg
IMG_4799.jpeg

TRS Sponsors


Sponsored Ad


Sponsored Ad


Amazon Deals

Sponsored Ad

Back
Top