- Joined
- Oct 15, 2007
- Messages
- 1,720
- Points
- 3,101
- Vehicle Year
- 1994/2002
- Transmission
- Manual
Well played...
Sent from my iPhone
Sent from my iPhone
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
PlumCrazy's Build
- Thread starter PlumCrazy
- Start date
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Pulled my front bumper last night to work on straightening it out and beefing it up.
I tweaked the driver side in a little which made the filler panel I had basically just tacked in for looks start to bow up. Lesson learned.... full weld it next time, even if you think its just for looks. lol
I will more than likely gusset it to the mount and maybe box it in.
I also started my 150A plug setup. I picked up some 1ga wire and crimped and heat shrinked the contacts and popped it together.
Ill mount it up once the bumper is back on.
Annnd we picked up some goodies for the B2....
EB 44 with radius arms. We also picked up a free lp closed knuckle 44 to steel the 4.09s out of.
Sent from my XT907 using Tapatalk 2
I tweaked the driver side in a little which made the filler panel I had basically just tacked in for looks start to bow up. Lesson learned.... full weld it next time, even if you think its just for looks. lol
I will more than likely gusset it to the mount and maybe box it in.
I also started my 150A plug setup. I picked up some 1ga wire and crimped and heat shrinked the contacts and popped it together.
Ill mount it up once the bumper is back on.
Annnd we picked up some goodies for the B2....
EB 44 with radius arms. We also picked up a free lp closed knuckle 44 to steel the 4.09s out of.
Sent from my XT907 using Tapatalk 2
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Bumper is straightened, welded, reinforced half ass painted, and bolted back on.
Mounted up my aux high amp plug, I still have to crimp lugs on the battery end.
Sent from my XT907 using Tapatalk 2
Mounted up my aux high amp plug, I still have to crimp lugs on the battery end.
Sent from my XT907 using Tapatalk 2
Last edited:
- Joined
- Jul 10, 2008
- Messages
- 1,439
- Points
- 3,101
- Age
- 39
- City
- Akron Ohio
- Vehicle Year
- 90
- Engine
- Transmission
- Manual
- Total Lift
- 6"
- Tire Size
- 44
Someday we will buy a winch. Someday we might actually need one lol
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Winch plug complete.
Chevy side posts are good for something.
Sent from my XT907 using Tapatalk 2
Chevy side posts are good for something.
Sent from my XT907 using Tapatalk 2
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Haha. Im just thinking that if the B2 gets stuck, no biggy, the blue turd can yank it right out. But if get the turd stuck....its STUCK.lol The B2 doesnt have the mass to move me.lol
Sent from my XT907 using Tapatalk 2
- Joined
- Jul 10, 2008
- Messages
- 1,439
- Points
- 3,101
- Age
- 39
- City
- Akron Ohio
- Vehicle Year
- 90
- Engine
- Transmission
- Manual
- Total Lift
- 6"
- Tire Size
- 44
I used to have a tow rig that could rescue me. Now I have one that gets stuck on wet grass...
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Lol. In thinking I can make a deal with Kyle...I wire up a 150A plug on the B2 (~$50) and he buys a winch(~$350)
Seems fair to me, but he says no
Sent from my XT907 using Tapatalk 2
- Joined
- Sep 14, 2010
- Messages
- 247
- Points
- 3,101
- City
- Milford, Mi
- Vehicle Year
- 1999
- Transmission
- Manual
Sounds fair to me too. I can always pull you out with my winch.
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Did the rear 150A disco last night.
I ran my positive to the rear battery, and that left me with only 8" of wire left, so the neg I just grounded to a bumper mount bolt.
I drilled and tapped the mounting holes since the bumper is boxed is boxed leaving no access to put nuts on the bottom. Homo Depot sells all their small hardware in packs of 3 apparently, so I need to grab one more stainless 10-24 to call it done.
Tap sockets are the best thing since sliced bread I swear.lol
Ill get pics of the final product tonight. I plan on throwing a disco on my jumper cables too.
Sent from my XT907 using Tapatalk 2
I ran my positive to the rear battery, and that left me with only 8" of wire left, so the neg I just grounded to a bumper mount bolt.
I drilled and tapped the mounting holes since the bumper is boxed is boxed leaving no access to put nuts on the bottom. Homo Depot sells all their small hardware in packs of 3 apparently, so I need to grab one more stainless 10-24 to call it done.
Tap sockets are the best thing since sliced bread I swear.lol
Ill get pics of the final product tonight. I plan on throwing a disco on my jumper cables too.
Sent from my XT907 using Tapatalk 2
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
Mounted up.
Sprayed the sh*t out of it with terminal protector.
Sent from my XT907 using Tapatalk 2
Sprayed the sh*t out of it with terminal protector.
Sent from my XT907 using Tapatalk 2
doorgunner
Lab Rat for V.A. hospital
U.S. Military - Veteran
2009 Truck of The Year
MTOTM Winner
V8 Engine Swap
- Joined
- Oct 22, 2008
- Messages
- 12,791
- Points
- 3,101
- Vehicle Year
- 1934/1989
- Engine
- Transmission
- Automatic
- Total Lift
- N/A
- Total Drop
- 3/4
- Tire Size
- 23570R15
- My credo
- JESUS Loves Ya!
Tap sockets... 
...where have I been?
...where have I been?
- Joined
- Nov 7, 2009
- Messages
- 1,802
- Points
- 3,101
- City
- White Pine, TN
- Vehicle Year
- 1988/1989
- Transmission
- Automatic
In New Orleans, trying to keep from sinking father then you are below the Sea Level.
Robert
sent with a Light bulb and can of grease.
PlumCrazy
20+ Year Member
⭐Supporting Member
TRS Event Participant
TRS 20th Anniversary
2014 Truck of The Year
OTOTM Winner
Solid Axle Swap
- Joined
- Sep 22, 2008
- Messages
- 4,724
- Points
- 3,101
- City
- Millersport, OH
- State - Country
- OH - USA
- Transmission
- Manual
I have never seen one of these before.
A rear panel with cupholders in a supercab 2 door...
So I bought it.lol
I also got a slick little external resi for a power steering pump. I wish it had one more barb though.
Sent from my XT907 using Tapatalk 2
A rear panel with cupholders in a supercab 2 door...
So I bought it.lol
I also got a slick little external resi for a power steering pump. I wish it had one more barb though.
Sent from my XT907 using Tapatalk 2
Sponsored Ad
Sponsored Ad
Special Events
TRS Events
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Recently Featured
TRS Latest Video
TRS Merchandise
Follow TRS On Instagram
