- Joined
- Jan 28, 2008
- Messages
- 139
- Points
- 3,101
- City
- Houston, tx
- Vehicle Year
- 1991
- Transmission
- Automatic
I got bored the other day so I decided to start on a little project. I had a small GPS unit sitting in my console and figured i could mount it somewhere in the dash, I am the third guy to do this at my shop. This was done in my 1991 ford ranger 2wd if anyone is wondering.
First I removed the dash trim panel, held on by clips, then removed the center AC vent.
After that I test fitted the unit to the vacant hole where a 4wd switch would have gone.
I trimmed the vent case so the GPS would fit and routed my power cord through the dash.
After all that was done I fit everything back together with the GPS installed.
Any questions just ask, an please leave feedback. It isn't finished yet i still want to reinforce where the GPS sits and get rid of the tape.
First I removed the dash trim panel, held on by clips, then removed the center AC vent.
After that I test fitted the unit to the vacant hole where a 4wd switch would have gone.
I trimmed the vent case so the GPS would fit and routed my power cord through the dash.
After all that was done I fit everything back together with the GPS installed.
Any questions just ask, an please leave feedback. It isn't finished yet i still want to reinforce where the GPS sits and get rid of the tape.
