- Joined
- Aug 10, 2007
- Messages
- 908
- Points
- 3,101
- Age
- 43
- City
- Jonesboro, AR
- Vehicle Year
- 1984
- Transmission
- Manual
pretty soon i will be pulling the '77 302 and np435 for the last time before it goes in for good.
before i put it back in, i figure i might as well throw on a new clutch and throwout bearing, but i have very little knowledge in this area.
-is there a specific clutch and throwout bearing for this transmission? it measures 11" wide
-besides clutch and throwout bearing, anything else i should replace while i'm in there?
-it's an external slave, and my stock setup (tk4) was external slave. anyone used the tk4 slave on an np435? i would like to retain the hydraulic clutch.
Thank you!
-Tony
before i put it back in, i figure i might as well throw on a new clutch and throwout bearing, but i have very little knowledge in this area.
-is there a specific clutch and throwout bearing for this transmission? it measures 11" wide
-besides clutch and throwout bearing, anything else i should replace while i'm in there?
-it's an external slave, and my stock setup (tk4) was external slave. anyone used the tk4 slave on an np435? i would like to retain the hydraulic clutch.
Thank you!
-Tony
