Auto Trans Issue

stuby · Nov 16, 2010

I had my tranny rebuilt about 5000 miles ago, and last week it dumed all fluid. I was driving down the road and it just all came out. Come to find out my bellhousing losened up from the tranny. So I took it out, put in a new seal and torqued the bolts back up. Now my tranny works fine in reverse when the tranny is cold and hot, but in drive it pulls well cold until the tranny warms up and then it slips and ingages at high rpm. Im thinkin maybe clutch pack? Any one have any input?

The_Dealer · Nov 16, 2010

mine does it too. cold its fine, but once it warms up it revs high and gains little speed...dunno what it is, maybe converter was killed from no fluid pumping through it

Shran · Nov 17, 2010

Take it back to who ever rebuilt it and tell them to fix it.

stuby · Nov 18, 2010

I would but it was over two years ago. The converter didnt run out of oil. And if it were bad reverse should not work either rite?? I tried adjusting the intermediate band and it did nothing.

Auto Trans Issue

stuby

15+ Year Member

The_Dealer

15+ Year Member

Shran

Junk Collector

stuby

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions