drive shaft for 205 to stock ranger axels

red rocket · Nov 15, 2010

ok got the 302 up and running got t5 and a np205 transfer case. the question i have is that what drive shafts can i use, the original drive shaft for the ranger is the right length just cant find any u joints to go from the original driveshaft to the 205 same with the front. so what will i have to do to get this to move on its own

Mac · Nov 15, 2010

Sounds like you need a conversion joint. Way down at the bottom of this: http://www.therangerstation.com/Magazine/summer2008/ujoints.htm
Dave

red rocket · Nov 15, 2010

where do i get these at

Mac · Nov 15, 2010

NAPA or any good auto store sure ought to have them. My '66' Ranchero 289 actually had them as stock so they shouldn't be hard to find.
Dave

red rocket · Nov 15, 2010

yea i went to the local advanced auto and they were no help, cause i need one to fit the 205 and the original drive shaft, the one for the drive shaft is very small so im going to try napa maybe they can help

drive shaft for 205 to stock ranger axels

red rocket

15+ Year Member

Mac

15+ Year Member

red rocket

15+ Year Member

Mac

15+ Year Member

red rocket

15+ Year Member

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions