- Joined
- Jan 17, 2008
- Messages
- 25
- Points
- 3,101
- City
- Regina,Sk.,Canada
- Vehicle Year
- 1984
- Transmission
- Automatic
I recently picked up a totalled off 92 Ranger 4x4 Ext cab for parts from the local salvage yard.I noticed that it seems to sit a couple of inches higher than a similar Ranger ext cab that is owned by one of my neighbors and the 235/75/15 tires seem to have plenty of clearance.I checked underneath and the body mounts look factory and comparing the suspension to that of my 84 Bronco II the only difference I can see is there is a factory appearing lift block between the rear axle and the spring and about a 1 inch metal spacer in the front under the coil spring.I am just wondering if I will run into any problems if I try to take the Ranger front and rear springs/spacers and try to put them on my Bronco II?
