- Joined
- Nov 23, 2007
- Messages
- 486
- Points
- 3,101
- Age
- 38
- City
- Dexter, Michigan
- Vehicle Year
- 1999
- Transmission
- Automatic
Oxygen Sensor Voltage Readout Questions....
replaced both of my upstream oxygen sensors today and decided to bench test the old ones. I took the propane torch to them and hooked up the trusty fluke. One read fine, getting up to 0.600 volts near the 20 second mark and returns back to 0.000 volts gradually. The other did the same in the beginning as well but when I removed the torch it dropped down to 0.000 volts quickly and then it read ~(-0.150) volts and slowly returned to 0.000 volts. Has that sensor gone on the fritz or am I just sounding like a noobie?
Also, the truck ran much smoother tonight than it ever has.
replaced both of my upstream oxygen sensors today and decided to bench test the old ones. I took the propane torch to them and hooked up the trusty fluke. One read fine, getting up to 0.600 volts near the 20 second mark and returns back to 0.000 volts gradually. The other did the same in the beginning as well but when I removed the torch it dropped down to 0.000 volts quickly and then it read ~(-0.150) volts and slowly returned to 0.000 volts. Has that sensor gone on the fritz or am I just sounding like a noobie?
Also, the truck ran much smoother tonight than it ever has.
Last edited:
