1350E to 1350M parts interchangability

88_Eddie · Oct 16, 2010

If any of you have seen my build thread (link in my sig), I just swapped a 1350E for a 1350M. I was gonna just scrap it yesterday, but then I thought that some of the parts may fit my manual case.

After seeing another thread where someone cracked the outside of their t-case, I thought I should hang on to whatever could be used if I break something in my manual case.

I know I can't use the front of the case, but what about the chain, planetary gears, etc.?

thanks in advance

lil_Blue_Ford · Oct 16, 2010

You can use the front plate on the case, it will swap between any 1350, I know some insides swap over too but not sure which ones. I had a 1350 dummy case in my choptop when I bought it, and I had a 1350 manual case that had a cracked front plate (the piece that bolts to the trans). The one off the dummy case fit the manual case perfectly, I just had to pull the clip and swap the planetary over. Wasn't hard at all.

country0001 · Oct 16, 2010

Good you got yours done. I'm doing mine next saturday

Snoranger · Oct 16, 2010

Most of the parts will swap into the 13-50m:

The front plate
The planet gear set/ input shaft
Output shafts (both front and rear)
Chain
Both shift forks and gears
Oil pump

Wont fit:
Rear case half (will work with some easy mods)
Front case half (will work with some major mods)
Shift rod

1350E to 1350M parts interchangability

88_Eddie

15+ Year Member

lil_Blue_Ford

Cut & Weld

country0001

15+ Year Member

Snoranger

Professional money waster

Sponsored Ad

TRS Events & Gatherings

Latest posts

Featured Rangers

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

Product Suggestions