xerofuzzion
New Member
- Joined
- Jul 7, 2010
- Messages
- 28
- Reaction score
- 0
- Points
- 0
- Location
- El Paso, Texas
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Size
- 3.0L V6
- Transmission
- Manual
Is it possible for any of you to do this for me?
Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
I will try to re-draw it in my cad program tomorrow after work. If I have any questions I will pm you. Wont be able to run it till this weekend. Both CNC machines are booked till end of week.Thanks swamprat, I think .250 should be good.
yeah the measurements are kinda bad. I just knew the holes had to be 7/8" from center to center, and each hole was 3/4" in diameter. The rest i kinda threw together.