So I picked up aset of the F250 shock mounts as shown in the tech library. Very beefy units I might add. Next week or two I expect to get them put in. But I wonder what others have done to gusset the back side of these mounts or gusset the back side of the cutup coil buckets.
I expect I'll slice some 2x2 square tube I have to make some gussets to weld to the backsides of the coild bucket and shock mount and then bolt to the frame.
And because a friend asked me and I don't know... What are the chances these wonderfully inexpensive mounts could hold up to coilovers if put in place of the coil buckets?
I expect I'll slice some 2x2 square tube I have to make some gussets to weld to the backsides of the coild bucket and shock mount and then bolt to the frame.
And because a friend asked me and I don't know... What are the chances these wonderfully inexpensive mounts could hold up to coilovers if put in place of the coil buckets?
