95 ranger bolt problem...


abart94

10+ Year Member

Joined
Jun 25, 2010
Messages
1
Points
3,001
Vehicle Year
1995
Transmission
Automatic
ok, i was driving down the road and my truck started sputtering and quit on me. i managed to pull off. upon inspection of the engine, i found that the bolts holding the air bypass controller are completely gone. i went to the dealer and the guy said he didnt know what size the bolts were. he guessed but the size he told me isnt even on the internet. can ANYBODY tell me what size bolts fasten on the air bypass on the side of the engine?!it is a 4.0 v6.
 
I can't tell you off the top of my head. If AllanD pops in he might know that particular obscure detail....


What I can tell you is how I go about solving those particular conundrums. You basically have two options:

A) Head on down to the local ACE with the truck. They are usually pretty cool about letting you grab a few small bolts and run out to the lot the see if they fit the hole.

or

B) Head on down to the local junk yard and go hunting.
 
not exactly sure what you're describing.. pics? we can judge the size and pitch from pictures.

probably M8 x 1.25
 
You must log in or register to reply here.

Sponsored Ad

TRS Events & Gatherings

Where We Were in 2025 – The Ranger Station

Latest posts

Featured Rangers

Want to see your truck here? Share your photos and details in the forum.

TRS Latest Video

Official TRS Merchandise

Follow TRS On Instagram

Latest Album Photos

IMG_4690.JPEG
IMG_4689.JPEG
IMG_4688.JPEG
IMG_4679.JPEG
IMG_4656.JPEG
IMG_4625.JPEG
IMG_4562.JPEG
IMG_4561.JPEG
IMG_4560.JPEG
IMG_4559.JPEG
IMG_4558.JPEG
IMG_4445.JPEG

Product Suggestions

Back
Top