well, i took a pair of side cutters, cut the plastic push rivets around the bottom, grabbed the old flares and yanked them off. then mounting was an experiment...driver side i drillout all the studs rivets and holders out with the same size drill bit as the pre-existing holes. then i drill the necessary holes for the new ones to snap on to...passenger side did the same, except i mounted them like the bushwacker flares on my 1990...i just held them in place drilled 5 pilot holes along the inside lip, and then put recessed screws up throught the bottom.9 (the screws are unseen)... anyway it takes about 45 min. per flare! any way thanks for the feedback guys i still need to get it aligned from the leveling kit, and get the bl on it. and im currently trying to find d35 manual hubs!