- Joined
- Feb 18, 2010
- Messages
- 10
- Points
- 3,101
- City
- Conyers GA
- Vehicle Year
- 2002
- Transmission
- Automatic
was doing some work on my Ranger this weekend. The intake manifold seals were leaking, causing a vacum leak throwing a code that both banks were running lean.
Anywho, when I was removing the upper intake manifold I noticed something that is wacky in my mind.
On the passenger side of the intake there are three hoses all going to this one fitting.
Back side of same fitting, sticks into intake.
One of the hoses feeding this fitting come off of one of the heater hoses.
If I stick my finger in the hole in the intake and look in from the throttle body I can see my finger. How is water not getting into the intake?
There is another hose from the same heater hose that runs to the back of the drivers side valve cover, why?
Anywho, when I was removing the upper intake manifold I noticed something that is wacky in my mind.
On the passenger side of the intake there are three hoses all going to this one fitting.
Back side of same fitting, sticks into intake.
One of the hoses feeding this fitting come off of one of the heater hoses.
If I stick my finger in the hole in the intake and look in from the throttle body I can see my finger. How is water not getting into the intake?
There is another hose from the same heater hose that runs to the back of the drivers side valve cover, why?
Last edited:
