Welcome Visitor! Please take a few seconds and 
CK3
New Member
- Joined
- Jun 14, 2009
- Messages
- 49
- Reaction score
- 0
- Points
- 0
- Location
- Minooka, IL
- Vehicle Year
- '89
- Make / Model
- Ford
- Engine Size
- 2.9L
- Transmission
- Automatic
Just for the hell of it.. I was thinking about pulling out the rear side windows on my '89 Bronco II & metaling them up. It's just a toy that after I'm done tossing the lift kit on, the entire truck will be sprayed flat black.
From this:
Too This:
I'm in the middle of doing a lift kit so it would have to be done here at my house in Minooka, Illinois 60447. I don't have a complete bodyshop but I have a plenty of tools, 220v Lincoln welder & shop compressor grinders, cutters.. ect... Who's up for a challenge??
Here's my goal (before the window project)..
-Bear
From this:
Too This:
I'm in the middle of doing a lift kit so it would have to be done here at my house in Minooka, Illinois 60447. I don't have a complete bodyshop but I have a plenty of tools, 220v Lincoln welder & shop compressor grinders, cutters.. ect... Who's up for a challenge??
Here's my goal (before the window project)..
-Bear
