- Joined
- Mar 10, 2010
- Messages
- 10
- Points
- 3,101
- Vehicle Year
- 1993
- Transmission
- Automatic
so i just picked up a 1993 ranger with a 4.0 and auto trans. truck starts right up and runs great, once i get on the road it will not shift unless i do it manually and will die after a couple of minutes. i can wait about 10 to 15 minutes and it will start right back up. any ideas
i checked the iac, and the maf,both are good, and i tried spacing out the kick down cable with zip ties. i also pulled the valve body out of the trans to check for blown gaskets, supposedly the previous owners put in a shift kit recently, i replaced the filter and retorqued everything correctly.
anyone had this type of problem i have gone back 60 pages in this forum( 4.0 forum ) and found only two that were somewhat similar
i checked the iac, and the maf,both are good, and i tried spacing out the kick down cable with zip ties. i also pulled the valve body out of the trans to check for blown gaskets, supposedly the previous owners put in a shift kit recently, i replaced the filter and retorqued everything correctly.
anyone had this type of problem i have gone back 60 pages in this forum( 4.0 forum ) and found only two that were somewhat similar
Last edited:
