wizkid00104
Active Member
- Joined
- Oct 15, 2007
- Messages
- 1,720
- Reaction score
- 13
- Points
- 38
- Location
- West Newton/Penn Hills, PA
- Vehicle Year
- 1994/2002
- Make / Model
- Ford
- Engine Size
- 2.3L/5.4L
- Transmission
- Manual
I just finished my t-case swap (1354 manual) in my 1994 ranger. I am about to install the t-case shifter and I noticed there is an awful lot of tension between the shifter and the shifter lever on the case. So much that it seems unsafe. I was going to space the shifter out from where it attaches to the tunnel between the tranny and t-case using washers so the fit is not so extreme. Will this work, or is that tight fit required for it to function properly.
or
Is putting a lot of lateral stress on the shifter lever of the t-case going to hurt it? I just had it rebuilt and I dont want to hurt my investment
or
Is putting a lot of lateral stress on the shifter lever of the t-case going to hurt it? I just had it rebuilt and I dont want to hurt my investment