- Joined
- Jul 11, 2009
- Messages
- 84
- Points
- 3,101
- City
- Dearborn heights mi
- Vehicle Year
- 1991
- Transmission
- Automatic
how does the clutch line detatch from the trans in a 91 2.3? i cant get it to come apart.
thanks
thanks
removing 2.3 clutch cable?
- Thread starter tjdeerslayer37
- Start date
- Joined
- Nov 12, 2008
- Messages
- 1,347
- Points
- 3,101
- City
- Nova Scotia Canada
- Vehicle Year
- 1997
- Transmission
- Manual
There's a large "quick release just outside of the bellhousing. small plastic washer that needs to be 'pushed in' to release the spring.
The part that is actually attached to the slave, inside the bellhousing, has a mall pin that needs to be driven out. This cannot be done while the bellhousing is attatched to the motor. (hence, the quick release)
The part that is actually attached to the slave, inside the bellhousing, has a mall pin that needs to be driven out. This cannot be done while the bellhousing is attatched to the motor. (hence, the quick release)
- Joined
- Jul 11, 2009
- Messages
- 84
- Points
- 3,101
- City
- Dearborn heights mi
- Vehicle Year
- 1991
- Transmission
- Automatic
right on thank you!
i wasnt sure if that pin was supposed to come out or not. ive got my motor out but left the trans in because i couldnt figure out how to detach it. im a little slowww
i wasnt sure if that pin was supposed to come out or not. ive got my motor out but left the trans in because i couldnt figure out how to detach it. im a little slowww
Sponsored Ad
TRS Events & Gatherings
Featured Rangers
TRS Latest Video
Official TRS Merchandise
Follow TRS On Instagram
